Stainless Steel Sheet Have A Higher Plastic Toughness

1. Unit thickness, the thicker the sheet, the greater the required bending force, and with the increase in plate thickness in the choice of bending equipment, the margin should be greater;

2. Unit size, the greater the tensile strength, the smaller the elongation, the greater the required bending force, the greater the bending angle should be;

3. In the design of the plate thickness and bending radius of the corresponding circumstances, according to experience, a bending of the Mirror Etching Silver Stainless Steel to expand the size of the right side of the addition of minus two thickness, fully meet the design accuracy requirements, according to the empirical formula to calculate the amount of development Simplify the calculation process to greatly improve production efficiency;

4. The greater the yield strength of the Mirror Etching Finish Decoration Sheet, the greater the amount of elastic recovery, in order to obtain the bending piece 90 degrees angle, the required angle of the knife to be designed smaller. Relative to the same thickness of carbon steel stainless steel bending angle is larger, this should pay special attention to the case will appear bending crack, affecting the workpiece strength.